Experiment #1
Experimental and Numerical Analysis of Tensile Test
Part A: Experimental study of Tensile Test
Part B: Numerical Analysis of Tensile Test.
Experiment #2
Experimental and Numerical Analysis of Flexural Test
Part A: Experimental study of Flexural Test
Part B: Numerical Analysis of Flexural Test.
Experiment #3
Numerically Calculation and MATLAB Simulation
Part A: Invariants, Principal stresses and strains with directions
Part B: Maximum shear stresses and strains and planes, Von-Mises stress
Part C: Calculate and Plot Stresses in Thick-Walled Cylinder
Experiment #4
Stress analysis of rectangular plate with circular hole under i. Uniform Tension and ii. shear
Part A: Matlab simulation for Calculation and Plot of normalized hoop Stress at hole boundary in Infinite Plate
Part B: Modeling of plate geometry under chosen load conditions and study the effect of plate geometry.
Part C: Numerical Analysis using FEA package.
Experiment #5
Single edge notched beam in four point bending.
Part A: Modeling of single edge notched beam in four point bending.
Part B: Numerical Studies using FEA.
Part C: Correlation Studies.
Experimental #6
Torsion of Prismatic bar with Rectangular cross-section.
Part A: Elastic solutions, MATLAB Simulation
Part B: Finite Element Analysis of any chosen geometry.
Part C: Correlation studies.
Experiment #7
Contact Stress Analysis of Circular Disc under diametrical compression
Part A: 3-D Modeling of Circular Discs with valid literature background, supported with experimental results on contact stress.
Part B: Numerical Analysis using any FEA package.
Part C: 2D Photo Elastic Investigation.
Experiment #8
Vibration Characteristics of a Spring Mass Damper System.
Part A: Analytical Solutions.
Part B: MATLAB Simulation.
Part C: Correlation Studies.