Calibration of Pressure Gauge
Calibration of Thermocouple
Calibration of LVDT
Calibration of Load cell
Determination of modulus of elasticity of a mild steel specimen using strain gauges.
Measurements using Optical Projector / Toolmaker Microscope.
Measurements of angle using Sine Center / Sine bar / bevel protractor
Measurements of alignment using Autocollimator / roller set
Measurements of cutting tool forces using a) Lathe tool Dynamometer b) Drill tool Dynamometer.
Measurements of Screw thread Parameters using two wire or three-wire method.
Measurements of Surface roughness. Using Tally surf/mechanical Comparator.
Measurements of gear tooth profile using gear tooth vernier /gear tooth micrometer.
Calibration of micrometer using slip gauges
Measurement using Optical Flats