10MEL37B MECHANICAL MEASUREMENTS AND METROLOGY LABORATORY syllabus for ME


Part A
Unit-1 MECHANICAL MEASUREMENTS 0 hours

Calibration of Pressure Gauge

Unit-2 MECHANICAL MEASUREMENTS 0 hours

Calibration of Thermocouple

Unit-3 MECHANICAL MEASUREMENTS 0 hours

Calibration of LVDT

Unit-4 MECHANICAL MEASUREMENTS 0 hours

Calibration of Load cell

Unit-5 MECHANICAL MEASUREMENTS 0 hours

Determination of modulus of elasticity of a mild steel specimen using strain gauges.

Part B
Unit-1 METROLOGY 0 hours

Measurements using Optical Projector / Toolmaker Microscope.

Unit-2 METROLOGY 0 hours

Measurement of angle using Sine Center / Sine bar / bevel protractor

Unit-3 METROLOGY 0 hours

Measurement of alignment using Autocollimator / Roller set

Unit-4 METROLOGY 0 hours

Measurement of cutting tool forces using a) Lathe tool Dynamometer b) Drill tool Dynamometer.

Unit-5 METROLOGY 0 hours

Measurement of Screw thread Parameters using Two wire or Three-wire method.

Unit-6 METROLOGY 0 hours

Measurements of Surface roughness, Using Tally Surf/Mechanical Comparator

Unit-7 METROLOGY 0 hours

Measurement of gear tooth profile using gear tooth vernier /Gear tooth micrometer

Unit-8 METROLOGY 0 hours

Calibration of Micrometer using slip gauges

Unit-9 METROLOGY 0 hours

Measurement using Optical Flats

Last Updated: Tuesday, January 24, 2023