10ME62 Design of Machine Elements II syllabus for ME


Part A
Unit-1 Curved Beams Cylinders & Cylinder Heads 8 hours

Curved Beams: Stresses in curved beams of standard cross sections used in crane hook, punching presses & clamps, closed rings and links Cylinders & Cylinder Heads: Review of Lame’s Equations; compound cylinders, stresses due to different types of fits, cylinder heads, flats.

Unit-2 Belts Ropes and Chains Flat belts 5 hours

Length & cross section, Selection of V-belts, ropes and chains for different applications.

Unit-3 Springs 8 hours

Types of springs - stresses in Helical coil springs of circular and non-circular cross sections. Tension and compression springs, springs under fluctuating loads, Leaf Springs: Stresses in leaf springs. Equalized stresses, Energy stored in springs, Torsion, Belleville and Rubber springs.

Unit-4 Spur & Helical Gears 7 hours

Spur Gears: Definitions, stresses in gear tooth: Lewis equation and form factor, Design for strength, Dynamic load and wear load. Helical Gears: Definitions, formative number of teeth, Design based on strength, dynamic and wear loads.

Part B
Unit-5 Bevel and Worm Gears 7 hours

Bevel Gears: Definitions, formative number of teeth, Design based on strength, dynamic and wear loads. Worm Gears: Definitions, Design based on strength, dynamic, wear loads and efficiency of worm gear drives.

Unit-6 Clutches & Brakes 5 hours

Design of Clutches: Single plate, multi plate and cone clutches. Design of Brakes: Block and Band brakes: Self locking of brakes: Heat generation in Brakes.

Unit-7 Lubrication and Bearings 7 hours

Lubricants and their properties, Mechanisms of Lubrication bearing modulus, coefficient of friction, minimum oil film thickness, Heat Generated, Heat dissipated, Bearing Materials, Examples of journal bearing and thrust bearing design.

Unit-8 IC Engine Parts 5 hours

Design of piston, connecting rod and crank shaft.

Last Updated: Tuesday, January 24, 2023