17MEL37B Mechanical Measurements and Metrology Lab syllabus for ME


Part A
Unit-1 MECHANICAL MEASUREMENTS 0 hours

MECHANICAL MEASUREMENTS

1. Calibration of Pressure Gauge

2. Calibration of Thermocouple

3. Calibration of LVDT

4. Calibration of Load cell

5. Determination of modulus of elasticity of a mild steel specimen using strain gauges.

Part B
Unit-1 METROLOGY 0 hours

METROLOGY

1. Measurement using Optical Projector / Toolmaker Microscope.

2. Measurement of angle using Sine Center / Sine bar / bevel protractor

3. Measurement of alignment using Autocollimator / Roller set

4. Measurement of cutting tool forces using a) Lathe tool Dynamometer OR b) Drill tool Dynamometer.

5. Measurement of Screw threads Parameters using two wire or Three-wire methods.

6. Measurement of Surface roughness, using Tally Surf/Mechanical Comparator.

7. Measurement of gear tooth profile using gear tooth Vernier /Gear tooth micrometer.

8. Calibration of Micrometer using slip gauges. 9. Measurement using Optical Flats.

Last Updated: Tuesday, January 24, 2023