17MEL47B Mechanical Measurements and Metrology Lab syllabus for ME



A d v e r t i s e m e n t

Module-1 PART A : MECHANICAL MEASUREMENTS 0 hours

PART A : MECHANICAL MEASUREMENTS

1. Calibration of Pressure Gauge

2. Calibration of Thermocouple

3. Calibration of LVDT

4. Calibration of Load cell

5. Determination of modulus of elasticity of a mild steel specimen using strain gauges.


A d v e r t i s e m e n t

Module-1 PART B: METROLOGY 0 hours

PART B: METROLOGY

1. Measurements using Optical Projector / Toolmaker Microscope.

2. Measurement of angle using Sine Center / Sine bar / bevel protractor

3. Measurement of alignment using Autocollimator / Roller set

4. Measurement of cutting tool forces using

a) Lathe tool Dynamometer OR

b) Drill tool Dynamometer.

5. Measurements of Screw thread Parameters using two wire or Three-wire methods

6. Measurements of Surface roughness, Using Tally Surf/Mechanical Comparator

7. Measurement of gear tooth profile using gear tooth Vernier /Gear tooth micrometer

8. Calibration of Micrometer using slip gauges

9. Measurement using Optical Flats

 

Course outcomes:

  • To calibrate pressure gauge, thermocouple, LVDT, load cell, micrometer.
  • To measure angle using Sine Center/ Sine Bar/ Bevel Protractor, alignment using Autocollimator/ Roller set.
  • To demonstrate measurements using Optical Projector/Tool maker microscope, Optical flats.
  • To measure cutting tool forces using Lathe/Drill tool dynamometer.
  • To measure Screw thread parameters using 2-Wire or 3-Wire method, gear tooth profile using gear tooth vernier/Gear tooth micrometer.
  • To measure surface roughness using Tally Surf/ Mechanical Comparator.

 

Scheme of Examination:

ONE question from part -A: 30 Marks

ONE question from part -B: 50 Marks

Viva -Voice:                         20 Marks

                               Total : 100 Marks

Last Updated: Tuesday, January 24, 2023