15MLL37 Analog Electronic Circuits Lab syllabus for ML



A d v e r t i s e m e n t

Module-1 0 hours

To design and testing of the following rectifiers with and withoutfilters: (a) Full Wave Rectifier (center tap) (b) Bridge Rectifier.

Module-2 0 hours

To plot characteristics of UJT and to determine its intrinsic stand-offratio.

Module-3 0 hours

To design and test the common emitter amplifier (voltage dividerbias) without feedback and determine input, output impedance, gainand bandwidth.

Module-4 0 hours

To design and test the Emitter follower amplifier (BJT) using voltagedivider bias and determine input, output impedance, gain andbandwidth.

Module-5 0 hours

To plot the Drain and Transfer characteristic for the given FET and tofind the Drain Resistance and Trans-conductance.

Module-6 0 hours

To design, test and to plot the frequency response of Common SourceJFET/MOSFET amplifier, and to determine its bandwidth.

Module-7 0 hours

To plot the input and output characteristics of n-channel MOSFETand calculate its parameters, namely; drain resistance, mutualconductance and amplification factor.

Module-8 0 hours

Wiring and testing of Complimentary symmetry class B push pullpower amplifier and calculation of efficiency.

Module-9 0 hours

To design and test the RC-Phase shift Oscillator using BJT for thegiven frequency.

Module-10 0 hours

To design and test the following tuned oscillator circuits for the givenfrequency. (a) Hartley Oscillator using BJT (b) Colpitts Oscillatorusing FET.

Module-11 0 hours

Testing of crystal oscillator and to determine its frequency ofoscillation.

Module-12 0 hours

Verification of Thevenin’s theorem and Maximum Power Transformtheorem for the given DC circuits.

Last Updated: Tuesday, January 24, 2023