1. Design and set up the following rectifiers with and without filtersand to determine ripple factor and rectifier efficiency:(a) Full Wave Rectifier (b) Bridge Rectifier
2. Conduct experiment to test diode clipping (single/double ended) andclamping circuits (positive/negative).
Conduct an experiment on Series Voltage Regulator using Zenerdiode and power transistor to determine line and load regulationcharacteristics.
Realize BJT Darlington Emitter follower with and withoutbootstrapping and determine the gain, input and output impedances.
Design and set up the BJT common emitter amplifier using voltagedivider bias with and without feedback and determine the gainbandwidthproduct from its frequency response.
Plot the transfer and drain characteristics of a JFET and calculateits drain resistance, mutual conductance and amplification factor.
Design, setup and plot the frequency response of Common SourceJFET/MOSFET amplifier and obtain the bandwidth.
Plot the transfer and drain characteristics of n-channel MOSFETand calculate its parameters, namely; drain resistance, mutualconductance and amplification factor.
Set-up and study the working of complementary symmetry class Bpush pull power amplifier and calculate the efficiency.
Design and set-up the RC-Phase shift Oscillator using FET, andcalculate the frequency of output waveform.
Design and set-up the following tuned oscillator circuits usingBJT, and determine the frequency of oscillation.(a) Hartley Oscillator (b) Colpitts Oscillator
Design and set-up the crystal oscillator and determine thefrequency of oscillation.